Sioux-chief 821 Series Shower Drain Bedienungsanleitung PDF herunterladen

Sioux Chief Manufacturing Company • tel: 1-800-821-3944 • www.siouxchief.com • fax: 1-800-758-5950

INSTALLATION INSTRUCTIONS

821 Series Shower Drain

For a wood subﬂ oor installation cut a 4.5” diameter hole in the center of the shower ﬂ oor where the drain will be positioned.

Disassemble the shower drain. Put the shower drain base in the opening so the ﬂ ange of the drain base rests on top of the subﬂ o o r .

Solvent weld the drain pipe into the drain base using the appropriate solvent cement.

Before applying the primary mortar bed, cover the drain base opening to keep debris from entering the drain. Apply primary mortar

bed over the subﬂ oor at 1/4” per foot slope from the wall framing to the top of, but not over, the ﬂ ange of the drain base. Take care

not to let mortar harden on the surface of the ﬂ ange or in the ﬂ ange groove.

NOTE: The sloped mortar bed should be ﬂ ush with the ﬂ ange of the drain base as shown.

When the primary mortar bed has cured, install the waterproof pan liner in the shower area according to the pan liner manufacturer’s

recommendations.

Very carefully cut out the center of the pan liner in the center of the drain base approximately ¼” inside the opening. Cut around

the bolt holes on the drain base to allow for insertion of the bolts. NOTE: Cut outs should be made as minimal as possible around

bolt holes just enough to start the bolts. DO NOT cut close to the ﬂ ange groove. Screw the clamping ring bolts into the bolt holes

approximately 2-3 threads deep. Place clamping collar over the bolts and twist into place making sure the pan liner remains ﬂ ush

to the ﬂ ange. The clamping collar and ﬂ ange are designed to mate together to form the seal with the pan liner. No adhesive is

necessary. Tighten bolts to ﬁ nish the seal.

Finish installing pan liner according to manufacturer’s recommendations. Test the pan liner by temporarily plugging the drain pipe

and ﬁ lling the shower ﬂ oor with water. Once tested, drain the water by removing the test plug. NOTE: Make sure the drain is

connected to the plumbing system.

Screw the head adapter (contains the strainer) of the drain into the clamping collar to the desired height. NOTE: Consider the

thickness of the ﬂ oor tile, and set height of the head adapter so there will be at least 1” of mortar around the top housing. Before the

application of the secondary mortar bed place some pea gravel over the weep holes so the mortar doesn’t completely cover them.

After the secondary mortar bed has set, proceed with installation of shower ﬂ oor tile

3HOWERFLOORTILE

3ECONDARYMORTARBED

SLOPEDFORPROPERDRAINAGE

7ATERPROOFPANLINER

0EAGRAVEL

3UBFLOOR

0RIMARYMORTARBED

SLOPEDFORPROPERDRAINAGE

$RAIN"ASE

&LANGE

#LAMPINGCOLLAR

(EADADAPTER

Sioux Chief Manufacturing Company • tel: 1-800-821-3944 • www.siouxchief.com • fax: 1-800-758-5950INSTALLATION INSTRUCTIONS821 Series Shower DrainFor

Keine Kommentare

Sioux-chief 821 Series Shower Drain Bedienungsanleitung